Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might discover that your garage door opener has actually been offering you troubles, so you need to fix it. You can fix it by changing a circuit board, a photo-eye sensing unit, the major drive gear, or the set-limit buttons. You can additionally check if the safety and security sensors are working correctly.

Changing a circuit board

Replacing a circuit board for your garage door opener needs a few steps and tools. Initially, you require to turn off the circuit breaker and disconnect any type of cords. Next, open up the motherboard cover. This will help you to detect the issue and establish if you need a new board. Next, remove the old board and also its cable connectors.

You can after that continue to replace the circuit board. The replacement process is simple as well as takes around 10 mins. A brand-new motherboard will certainly cost regarding $80. To safeguard your new circuit card from power rises, you can acquire a rise guard.

Changing a photo-eye sensor

Changing a photo-eye sensor can be a fairly basic job. Initially, remove the sensor from the door as well as see to it is positioned correctly. If the sensing unit is angled in any way, it may not be getting the right signal, which might be triggering the blinking lights. If you observe that the photo-eyes are out of placement, you may require to have actually a professional come as well as take care of the issue.

The photo-eye sensing unit includes 2 pieces that mount outside of the door tracks and towards the floor. The image eyes will have a small LED light and also need to be strong in color. If the light is blinking, its likely the photo-eye is faulty and also will certainly need to be replaced.

Replacing a major drive gear

To replace a garage door opener main drive gear, beginning by getting rid of the cap from the chain sheave. Next off, get rid of the two screws holding the drive gear to the sprocket assembly. Currently, you can loosen the 3 tension pins. Press them from both sides and then remove them. After that, disconnect the three cords from the garage door opener electric motor. These cords need to be white, red, and blue.

As soon as you have gotten rid of the old equipment, set up a brand-new one. Be sure to grease it well. Insert the brand-new equipment into the shaft, seeing to it to line up the mounting openings. Make certain the gear as well as sprocket setting up are positioned properly to make sure smooth procedure. Next off, use a hammer and a nail to drive a pin right into the new equipment.

Readjusting the set-limit switches

The first point you must do if your garage door is not functioning effectively is to check the set-limit switches. You may require to adjust them to ensure that the door shuts earlier or quits prior to it reaches the floor. You can examine this by checking out your garage doors handbook or online.

To change the set-limit switches, youll need a screwdriver or outlet. Readjust the knob clockwise or counterclockwise up until the door moves up and also quits, or lowers its distance. To check for proper traveling distance, determine the space from all-time low of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Garage Door Repair Garage Door Repair near me